How to Apply UV Transfers to a Substrate

Before you start:

• Always test on a sample substrate first before full application.

• Substrate must be thoroughly cleaned with a wet IPA wipe, then dried using a lint-free cloth.

1. Clean the Substrate

Ensure the substrate is wiped down with IPA (Isopropyl Alcohol), removing all dust and oils.

2. Dry the Substrate

Make sure the surface is completely dry before proceeding.

3. Peel the Transfer

Carefully peel the UV transfer away from the backing sheet.

4. Apply the Transfer

Place the transfer directly onto the prepared surface, ensuring correct positioning.

Note: Once applied, the transfer cannot be repositioned or removed.

5. Rub the Transfer

Firmly rub down the entire transfer, ensuring good adhesion.

6. Peel Laminate (if applicable)

Carefully peel away any laminate layer, if included.

• Allow 48 hours for the adhesive to fully bond.

• Hand wash only recommended.

• Avoid scrubbing the decorated area.

• Not suitable for surfaces that flex, stretch, get hot, or require abrasive cleaning.